Manufacturers

Manufacturer Info

Sponsors

migliai di prodotti

Who's Online

There currently are 89 guests online.

7-Speed DSG DQ381 Volkswagen Tiguan Transmission Control Unit

  • Model: TCU-0GC-TIG
  • Manufactured by: (TCU)Cambio Automatico

This is the request form and does not bind you to any purchases. Fill it out as thoroughly as possible to let me know what you want to repair and what defect needs to be corrected, so I can confirm feasibility or suggest alternatives. SUBMIT YOUR REQUEST EVEN IF YOU ARE UNSURE, SPECIFYING YOUR DOUBTS. Instructions on the intervention method will be provided later, based on the requested service. Scroll down the page to review the cases independently.

Send only the control unit




3-6 working days






Describe the fault as indicated by your customer, warning lights





Automatic Transmission Control Unit DQ381 (0GC - 0DE) Overhaul

The new DSG7 mechatronics from Volkswagen, called DQ381, is known for its vulnerability despite the excellent performance it can provide. This unit can often cause issues. Common symptoms of failure include:

  • Inability to select gears. The fault occurs during long journeys, mainly when the vehicle is hot.
  • The gearbox goes into emergency mode until the engine is turned off and on again.
  • The gearbox jolts during some gear changes and sometimes only engages even or odd gears.

The sentinel fault codes related to this issue are as follows, associated with a failure to read clutch pressure:

  • P173500 – Clutch Position Sensor 1 Electrical Malfunction
  • P173600 – Clutch Position Sensor 2 Electrical Malfunction

These fault codes can be cleared, but they usually reappear. I can fix the fault and ensure it does not reoccur, all at a very low cost. After the repair, it will not be necessary to reprogram the unit; just perform clutch learning by following the procedure on the hot engine diagnosis.

Customer reports:

  • "The yellow gear indicator light appears on the side, and the message 'Gearbox in emergency function' appears on the display. You can continue driving, but after turning the ignition off and on again, the gearbox starts working again, and the issues disappear, only to reappear after a short drive."

Fault codes detected in some processes:

  • DTC P173500 – Clutch Position Detection Sensor 1
  • DTC P173600 – Clutch Position Sensor 2
  • DTC P1735 – Clutch Position Sensor 1
  • DTC P1736 – Clutch Position Sensor 2
  • P173E – Valve 1 in Gearbox Part 1 - Electrical Fault
  • P173F – Valve 2 in Gearbox Part 1 - Electrical Fault

Some revised product codes:

This product was added to our catalog on Wednesday 22 November, 2023.

Your IP Address is: 216.73.216.108
Copyright © 2026 CAMTECH SRL. Powered by CamTech S.r.l.
Privacy Policy Cookie Policy